2x2 Indoor & Outdoor Access Points
Revision: A0-00
43
CONFIDENTIAL
10.1.1.3
DHCPv6 client configuration
If the protocol is set to DHCPv6 client, the device will automatically get the IPv6 address from the DHCP server.
Refer Figure 19: Basic overview of the network interface setup configuration screen to switch protocol and set the
protocol to DHCPv6 client.
Refer the figure below to provide the DHCPv6 client parameters:
Figure 22: Basic overview of DHCPv6 client parameters for general network interface setup
Follow the steps given below to provide DHCPv6 client parameters:
Table 14: List of actions to provide DHCPv6 client parameters
Callout
Name
Description
1.
Protocol
The protocol is set to “DHCPv6 client”. The IPv6 address
and the other parameters will be taken care by the DHCP
server. Enter the following parameters
2.
Dual Stack
Enable/Disable the dual stack
3.
WLC IPv6 address
Enter the WLC IP address in IPv6 format
4.
WLC IPv4 address
Enter the WLC IP address in IPv4 format
5.
AP Host Name
Enter a unique name for the AP
Click “Save” to save the general network setup configuration or click “Reset” to configure the same again.