2x2 Indoor & Outdoor Access Points
Revision: A0-00
41
CONFIDENTIAL
Follow the steps given below to provide static address parameters:
Table 12: List of actions to provide static address parameters
Callout
Name
Description
1.
Protocol
The protocol is set to “Static address”. Enter the following
parameters
2.
IPv4 address
Enter the “IPv4 address”. This is a unique address of the
Host/Device eg.192.168.100.10
3.
IPv4 netmask
Select the “IPv4 netmask” from the dropdown list or select
“Custom” option to enter it manually. This specifies the
number of bits for network part and host part
e.g.255.255.255.0
4.
IPv4 gateway
Enter the “IPv4 gateway”. Gateway address is given to reach
other network device e.g.192.168.100.254
5.
IPv4 broadcast
Enter the “IPv4 broadcast”. Broadcast address is to
broadcast message in a network e.g. 192.168.100.255
6.
Use custom DNS servers
Enter the “DNS server”. Click on add icon to add multiple
DNS servers. DNS server is to resolve the transition of
domain name to IP and IP to domain name
7.
IPv6 Assignment Length
Enable/Disable the IPv6 assignment length for IPv6 address.
Specify the number of bits that belong to network part, if
enabled. The prefix-length specifies a range of devices
e.g. IPv6 prefix length = 64 means range of IP addresses
between 2001:0DB8:ABCD:0012:0000:0000:0000:0000 and
2001:0DB8:ABCD:0012:FFFF:FFFF:FFFF:FFFF
8.
IPv6 address
Enter the “IPv6 address”. Unique address of the Host/Device
e.g.2001:11::100
9.
IPv6 gateway
Enter the “IPv6 gateway”. Gateway address is given to reach
other network device e.g.2001:11::1
10.
IPv6 Routed prefix
Specify the prefix length for IPv6 address. Specifies the
number of bits that belong to network part. The prefix-
length specifies a range of devices
e.g. IPv6 prefix length = 64 means range of IP addresses
between 2001:0DB8:ABCD:0012:0000:0000:0000:0000 and
2001:0DB8:ABCD:0012:FFFF:FFFF:FFFF:FFFF
11.
WLC IPv4 address
Enter the WLC IP address in IPv4 format
12.
WLC IPv6 address
Enter the WLC IP address in IPv6 format
13.
AP Host Name
Enter a unique name for the AP
Click “Save” to save the general network setup configuration or click “Reset” to configure the same again.