BladeZ Corporation • 20155 Ellipse • Foothill Ranch • CA • 92610
www.ebladez.com
20
SECTION 5
PREVENTIVE MAINTENANCE
If the running belt has shifted to the left or
right of center or simply stops short (slips)
when running, please refer to the
following
1.
Turn the power off.
2.
Use a 6mm wrench to tighten the
rear roller bolt on the side of the
treadmill toward which the belt is
moving as shown.
3.
Tighten about 1/4 of turn
(clockwise).
Note: If the belt does not move
back to the center of the treadmill,
make another adjustment to the
same bolt until the running belt
moves closer to the center.
Once the running belt has been
adjusted closer to the center, the
treadmill can be powered on again.
It is recommended that the deck be
lubricated every 6~12 months according to
the frequency of usage.
Use 6mm allen wrench to loosen the bolts
in the end caps. Remove excessive
accumulations of dust, dirt, and other
substances from running deck. Use a clean
soft cloth.
Warning!
Do not use cleaner under the
running belt.
Pull up running belt, dispense lubricant on
deck, and spread evenly.
After lubricating deck, center the belt, and
tighten the end caps. Check belt condition
and adjust if necessary referring to the
steps above.
Rear Roller Bolt
6 mm allen wrench
0.5~4.0 Mile lubricate every 1 year
4.0~7.0 Mile lubricate every 6 months
7.0~10.0 Mile lubricate every 3 months
