28
Ioline FlexJet User Guide
4.
Close the stall latch. If the cartridge is inserted properly, the
latch will snap shut and securely hold the cartridge. Do not
force the latch. If the latch does not close properly, remove and
reinsert the cartridge.
Printing a Marker
Overview
The basic steps required to print a marker on the FlexJet are:
1.
Turn the printer and computer power on.
2.
Load paper.
3.
Install cartridges in the stalls.
4.
Set an origin.
5.
Start
FlexPlot
or your design application.*
6.
Send marker/plot files.
These steps are outlined in the next several sections. In most cases
the design files are sent to the printer from
FlexPlot
or the design ap-
plication. If necessary, use the Ioline
Control Center
to send design
files or adjust settings.
General Guidelines
1.
Good paper loading makes good plots. Follow loading instruc-
tions carefully.
2.
Ensure that the paper roll is centered on the feed shaft by align-
ing the paper hub with the guideline marks.
3.
Keep the plastic feed shaft block clean and well lubricated.
4.
Use the
FlexPlot
software for optimal file management and
printing throughput.
Figure 15.
Insert ink cartridges at an angle into the cartridge bay. Lock in place with
the stall latch.
*
Refer to the FlexPlot User Guide
for information on set-up and
configuration.
