IOGear GCN1000 PCPortal, Installation Manual

Page: 23 / 48

23
An explanation of the Customization parameters is given in the table below:
Parameter Explanation
Time out Control If the GCN1000 does not receive any input from a computer that is
accessing it with either client within the time speci
fi ed, the connection
terminates.
Login failure Login failures allowed: Sets the number of consecutive failed login attempts
that are permitted from a remote computer.
Login failure timeout: Sets the amount of time a remote computer must wait
before attempting to login again after it has exceeded the number of allowed
failures.
Working Mode Enable stealth mode: With stealth mode enabled, the GCN1000
will not reply to a ping request.
Reset on exit A check here causes the GCN1000 to reset itself and implement all the new
changes when you log out. A wait of approximately 30 to 60 seconds is
necessary before logging in following the reset.
Firmware
As new versions of the GCN1000 fi rmware become available, they can be downloaded from our website.
Check the website regularly to fi nd the latest information and packages.
To upgrade the fi rmware, do the following:
1. After downloading the new fi rmware fi le to your computer, open your browser; log in to the GCN1000;
and click the Firmware icon to bring up the Firmware File dialog box:
2. Click Browse; navigate to the directory that the new fi rmware fi le is in and select the fi le.
3. Click Upload.
4. After the upload completes, click the Apply icon at the left of the web page.
5. Enable the Reset on exit checkbox on the Customization page.
6. Click the Apply icon at the left of the web page, again.
7. Click the Logout icon at the upper right of the web page to exit and reset the GCN1000.