26
Turning On the UPS
Press the ON/Mute button on the front panel for two seconds to power IOGEAR UPS on
Note: The battery charges fully during the first 5 hours of normal operation. Do not expect full battery run
capability during this initial charge period
EPO Function
IOGEAR UPS is equipped with EPO function. By default, the UPS is delivered from factory with Pin 1 and
Pin 2 closed (a metal plate is connected to Pin 1 and Pin 2) for UPS normal operation. To activate EPO
function, remove two screws from EPO port and remove the metal plate.
Note: The EPO function logic can be set up via LCD setting. Please refer to EPO Logic Setting for details.
Initial Software
For optimal computer system protection, install the UPS monitoring software to fully configure UPS
shutdown. Use the included RS-232 or USB communication cable to connect the RS-232/USB port of the
UPS and RS-232/USB port of the PC. Then, please follow below steps to install monitoring software
1. Insert the included installation CD into CD-ROM drive then follow the on-screen instructions
to proceed software installation. If there no screen shows one minute after inserting the CD,
please execute setup.exe for initiating software installation.
2. Follow the on-screen instructions to install the software
When your computer restarts, the monitoring software will appear as an orange plug icon located in
system tray, near the clock.
General Operations
Summary of Contents for GBB1000N
Page 2: ......
Page 52: ... 2020 IOGEAR ...
