23
Installation
For safety, the internal battery of the unit is disconnected by default. Please follow steps below
to reconnect the battery wires
Refer to the diagram following the steps below to connect the UPS
Note: GBB1000N is used in this case
1. Connect electrical appliances to the non-critical power outlets
2. Connect electrical appliances (that you do not wish to have power cut off) to the critical
power outlets
3. (Optional) Connect the external battery to the External Battery Connection Port. Please refer
to External Battery Connection
4. (Optional) Connect a modem/phone/fax source (using a corresponding cable) into the
surge-protected “IN” outlet Connect an equipment (you wish to have surge protection for)
to the “OUT” outlet using another modem/fax/phone cable
5. (Optional) Connect the USB Type-B end of the included USB cable to the unit and the USB
Type-A end to a USB port on your PC
6. (Optional) Connect the included RS-232 cable between the RS-232 port of the unit and a
communication port of your PC
7. (Optional) Connect GICBP100 card for advanced communication and monitoring options
8. Connect the power cable to an AC power socket.
1
6
3
7
2
5
4
8
Modem/Phone/Fax Source
Modem/Phone/Fax Outlet
Non-Critical Powered Devices
Critical Powered Devices
External Battery
SNMP
Summary of Contents for GBB1000N
Page 2: ......
Page 52: ... 2020 IOGEAR ...
