34
INSTALLATION AND ASSEMBLY
34
iV-Office ventilation device | Installation instructions
4.10 Installing the inner cover panel
Requirements:
• The thermal accumulator insert has been installed.
Ensure you install the dust filter properly to avoid a
malfunction of the ventilation device.
► Insert the dust filter into the base plate.
•
Push the filter ring firmly between the
fixing tabs and the inner edge of the base
plate.
•
The tab on the filter ring faces the inside
and is located in the cut-out provided in
the base plate.
►
Place the panel on the four spacers.
The position arrows on the back of the
inner cover panel point upwards.
Check:
The inVENTer logo is located at the
bottom right
►
Press the locking lugs inwards on the spacers.
►
Slide the inner cover panel onto the spacers.
All spacers noticeably snap in.
The inner cover panel is fitted.
The assembly of any internal termination variants is not part of this documentation!
It can be found in the separate installation instructions for the respective component.
4 x CLICK
!
!
!
