using the blender with the glass blender jug
4
English
•
11
Before plugging into a socket, check that the voltage in your home corresponds with the voltage printed on the bottom of the
appliance.
1. Place the blender on a flat, clean and dry surface.
2. Make sure that the blender is not activated.
3. Put the ingredients in the glass jug and lock it with the lid.
4. Switch the blender on by selecting a position with the position button.
Attention: Do not activate the mixer constantly, this can cause engine problems. Do not use the mixer for more then 1 minute
continuously, wait 1 minute before you operate it again.
5. When the blender has finished mixing switch the button to off (0) and wait until the blades have stopped turning., before you
remove the glass blender jug.
tips
6
• When the glass blender jug is cracked, do not use the mixer anymore. This could lead to damage while using the mixer.
• To avoid splashes always place the lid on the blender jug.
• Always add liquid ingredients before adding solid ingredients in the mixer.
• The mixer mixes best when you do not add pieces which are too large.
• Always add a half a cup of liquids when you crush ice cubes.
Attention: Only crush ice cubes in the glass blender jug.
• To add ingredients while the mixer is activated, take the cap out of the lid and add the ingredients through the opening.
• When the ingredients stick to the sides of the glass jug or are not mixed properly, shut off the engine: wait until the knives have
stopped turning and push the ingredients with a spatula towards the knives.
• To prevent the ingredients from being blend to small, take into account that the mixer mixes in seconds, not minutes!
• Working with warm ingredients can cause a build-up of pressure in the jug and that can cause hot liquids to escape when you take
the lid of the glass jug. Therefore always remove the cap from the lid when you are processing warm ingredients.
using the blender with the to-go bottle
5
Before plugging into a socket, check that the voltage in your home corresponds with the voltage printed on the bottom of the
appliance.
1. Place the blender on a flat, clean and dry surface.
2. Make sure that the blender is not activated.
3. Put the ingredients in the bottle and lock it by firmly turning on the blade set. Turn the drinks bottle around and place it upright on
the motor base unit. Make sure that the •• indications are in line and click the bottle tight by turning it slightly to the left.
4. Switch the blender on by selecting a position with the position button.
Attention: Do not activate the mixer constantly, this can
cause engine problems. Do not use the mixer for more then 1 minute continuously, wait 1 minute before you operate it again.
5. When the blender has finished mixing switch the button to off (0) and wait until the blades have stopped turning.
6. Click the bottle loose -
do not turn too far
- and lift it from the motor base unit.
Attention:
if you turn the bottle too far you turn
the bottle off the blade set and the contents will flow out of the bottle.
7. Turn the drinks bottle around, remove the blade set and firmly turn the lid with drinking spout onto the drinks bottle. You’re ready to
go!
Attention: you cannot crush ice cubes or make warm dishes in the to-go drinks bottle.
