![background image](http://html.mh-extra.com/html/invenco/g6-opt-6500x/g6-opt-6500x_installation-manual_2083794031.webp)
Invenco Group Limited Proprietary & Confidential
Follow the steps below to reinstall a G6 OPT:
Step
Description
1.
If you are swapping one G6 OPT for another, proceed to step 2.
To prepare the terminal, you will need to remove the existing sealing
gasket and replace it with a new one.
a.
The gasket is strongly fixed to the terminal and must be scraped off
with a soft scraper.
b.
Use isopropyl alcohol to remove any remaining adhesive.
c.
Apply a new gasket by removing the THIN paper backing and
carefully positioning it over the G6 OPT rear cover.
Align the gasket before pressing down gently all around.
d.
Gently remove the cardboard backing just before you reinstall the
terminal.
2.
Place the G6 OPT carefully into the cut-out in the door, and align it with
the screw-holes or with the brackets if this is a retrofit.
3.
Start the screws into the G6 OPT
but don’t tighten them.
4
Make sure the G6 OPT is properly aligned, and then tighten the screws.
a)
If this is a retrofit and you are reinstalling the brackets, press the G6
OPT onto the door before tightening the screws, to ensure a good
seal.
b)
If this is a retrofit and you are only replacing the G6 OPT, make sure
the terminal is not twisted in the cut-out, and lines up with external
features of the door/pump before tightening the screws.
5
Plug in the LAN cable and the low-voltage power cable, and reconnect
the Ground wire.
6.
Use new cable ties to secure the cables to the G6 OPT.
Ensure that the cables are tied so that they will not be snagged or
pinched when the door is opened and closed.
7.
Switch on the mains power supply and check that the G6 OPT powers up
correctly.
8.
Replace the paper roll in the G6 OPT and feed the paper into the printer.
9.
Check that the G6 OPT has come online correctly, and then close the
door.
Summary of Contents for G6 OPT 6500x
