Invenco G6 OPT 6500x, Installation Manual

Page: 18 / 40

Invenco Group Limited Proprietary & Confidential
4.4.2 Selection of Retrofit Options
There are two distinct models of G5 OPT that can be replaced with a G6 OPT. Below are the models
of G5 OPT, and the list of associated parts needed for a retrofit for each.
Motorised Card Reader
(Side-Mounted) Requires EZ0123 Retrofit Kit 1 , containing:

MP0146
– Left Side Bracket

MP0147
– Right Side Bracket

MS0044
– M4 Screws (qty=8)
Manual Card Reader
(Top/Bottom-Mounted) Requires EITHER EZ0124 Retrofit Kit 2 , containing:

MP0136
– Top Bracket

MP0137
– Bottom Bracket

MS0044
– M4 Screws (qty=8)
OR
EZ0125 Retrofit Kit 3 , containing:

MP0156
– Front Escutcheon Mount

MS0044
– M4 Screws (qty=8)
4.4.3 Physical Retrofit
Step Description
1. Remove the existing G5 OPT.
2. Disconnect the mains power to the power supply in the normal way.
3.
Unplug both the low-voltage connector and Ethernet connector.
Retain the Ethernet cable for later reconnection.
Disconnect the low-voltage cable from the power supply and replace it with either:

cable EK0070 (available from Invenco), or

the cable specified and supplied by your customer.
4. Remove the plastic front bezel around the G5 OPT and discard.
5.
Loosen, and then remove the four M4 mounting screws holding the G5 OPT to the
door.
6. Remove the G5 OPT from the back of the door, and package it for disposal or return.
7.
Open the retrofit kit and check the contents. It should have one or two brackets
(depending on kit purchased) appropriate to convert the existing to G6 OPT version,
and eight screws.
8.
Check the bracket placing
– they are not symmetric.
Use the pictures below as a guide.
9.
Use four of the supplied screws to mount the bracket(s) onto the door.
Leave the screws loose so the brackets can move a little.
10. Remove the G6 OPT from its packaging, and inspect it for damage.
11. The sealing gasket will be in the carton with the G6 OPT.