Adjusting the mobility device to the user's seating posture
Installing
1.
Position the footboard assembly onto the frame so that the
mounting hole
E
in the frame aligns with the desired mounting
hole in the footboard assembly.
2.
Install the quick release pin
B
by depressing the button
A
while
sliding the pin in. Ensure that the detent balls
C
are engaged
with the outer edge of the tube
F
(Detail “A”).
5.4.2
Adjusting the footboard assembly angle
Tools:
•
5/32” Allen Key
•
1/2” socket wrench
1.
Loosen the jam nut and set screw
A
located underneath on the
backside of the footboard
B
.
2.
Adjust the set screw in or out to obtain the desired footboard
assembly angle.
3.
Thread the jam nut and washer inward until it is flush with the
footboard bracket.
4.
Securely tighten the jam nut and washer to secure the mounting
screw in place.
5.4.3
Adjusting the footboard assembly depth
WARNING!
Make sure the detent balls of the quick-release
pin are fully released beyond the outer edge of
the tube before operating the mobility device.
Otherwise, injury and/or damage may result.
–
Keep detent balls clean.
Detail “A”
1.
Remove the quick release pin
A
that secures the footboard
assembly
C
to the frame.
2.
Adjust footboard to one of three mounting positions
D
.
3.
Install the quick release pin. Make sure the detent balls
B
are
engaged with the outer edge of the tube
E
(Detail “A”).
1590425-A
27
Summary of Contents for Wheelchair Pronto M61
Page 46: ...Invacare Pronto M61 Series with SureStep Use only batteries of the same type 46 1590425 A...
Page 65: ...Notes...
Page 66: ...Notes...
Page 67: ...Notes...
