SECTION 9—WHEELS
Crossfire
™
T6A Wheelchair
54
Part No 1134343
Removing/Installing the Camber Tube
WARNING
Camber tube clamps - Make sure the clamp screws are securely tightened before
using the wheelchair, otherwise personal injury or damage to the wheelchair may
occur.
NOTE:
For
this
procedure,
refer
to
FIGURE 9.11.
Removing the Camber Tube
1. Remove
the
rear
wheels.
Refer
to
Removing/Installing
Rear
Wheels
on
page 45.
2. Loosen
the
two
socket
head
clamp
screws
securing
camber
tube
to
the
two
camber
tube
clamps.
3. Slide
the
camber
tube
through
he
camber
tube
clamps.
Installing the Camber Tube
1. Insert
the
camber
tube
into
the
camber
tube
clamps.
2. Center
the
camber
tube
in
the
camber
tube
clamps.
3. Adjust
the
camber
tube.
Refer
to
Adjusting
the
Camber
Tube
on
page 55.
NOTE:
There
are
four
types
of
camber
tubes:
0°,
3°,6°
and
9°.
If
the
camber
tube
being
used
is
3°,6°
or
9°
degrees,
then
the
camber
tube
MUST
be
rotated
so
that
the
axle
bushings
at
the
ends
of
camber
tube
are
angled
up
(Detail
“A”).
Installing
the
camber
tube
in
any
other
orientation
will
directly
impact
the
angle
of
the
rear
wheel.
FIGURE 9.11
Adjusting Wheelbase Length, Adjusting Center of Gravity (COG)
Camber Tube
Clamp
Camber Tube
DETAIL “A” - CORRECT ORIENTATION FOR
EACH CAMBER TUBE
0° angle
3 ° angle
6° angle
9° angle
Camber
Tube
Axle
Bushing
Camber
Tube
Clamp
Socket Head
Clamp Screw
Socket Head Clamp Screw
