Invacare TOP END Crossfire T6A, Owner'S Operator And Maintenance Manual

Page: 51 / 68

SECTION 9—WHEELS
Part No 1134343
51
Crossfire
™
T6A Wheelchair
Repositioning the Camber Tube Clamps
NOTE: For this procedure, refer to FIGURE 9.7.
1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 45.
2. Loosen, but DO NOT remove, the four socket screws and washers that secure the two
camber tube clamps to the camber tube supports.
3. Slide the camber tube forward or backward to adjust the wheelbase length to the
desired position.
NOTE: Ensure that both camber tube clamps are adjust to the same position in the camber tube
support. This will ensure that the camber tube remains at 90° to each side frame.
4. Securely tighten the four socket screws and washers that secure the two camber tube
clamps to the camber tube supports.
5. Install the rear wheels. Refer to Removing/Installing Rear Wheels on page 45.
FIGURE 9.7 Repositioning the Camber Tube Clamps
Repositioning the Camber Tube Clamp Socket Screws
NOTE: For this procedure, refer to FIGURE 9.8 on page 52.
1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 45.
2. Refer to Socket Screw Mounting Positions in FIGURE 9.6 to determine which socket
screw(s) MUST be moved and to which mounting positions.
3. Remove the four socket screws and washers from both camber tube clamps.
Camber
Tube
Socket Screws
and Washers
Camber Tube Support
Camber
Tube
Clamp