![background image](http://html.mh-extra.com/html/intex/purespa-sjb-hs-11/purespa-sjb-hs-11_manual_2081128022.webp)
2016-0685
2017-10-02
STORAGE
1.
Drain and clean the spa following the “Spa Tub Drainage” and “Spa Tub Cleaning”
sections.
2.
Reverse set up instructions to deflate and disassemble the spa tub,
spa control unit and spa cover air bladder.
3.
To deflate the tub and the cover air bladder:
a)
Open the deflation outlet cap
(35)
with the included bolt wrench
(6) (see drawing
17)
.
b)
Insert deflation hose adaptor
(36)
into the deflation outlet.
c) Insert inflation hose
(7)
over the deflation hose adaptor
(36)
.
d) Insert the other end of the inflation hose into the tub air valve
or cover air bladder
valve.
e) Press the air bubble button to deflate.
f) When deflation is completed reverse above steps and
ensures the deflation
outlet cap
(35)
is securely fastened.
Caution:
Only use for the purpose described in this manual.
Keep the inflation hose away from
water or small objects when the
deflation function is activated to avoid
damage to the blower motor.
4.
Make sure all the spa components and accessories are thoroughly
clean and dry
before storage. Air-dry the spa tub in the sun for an hour before folding.
5.
Fold the spa tub loosely and avoid any sharp corners to prevent
damage or
leakage to the spa tub liner.
6.
Prepare additional new cartridges for next time use.
7.
Store the spa tub and accessories in a dry, temperature controlled,
between 0º – 40ºC (32º – 104 ºF), storage location.
8.
The original packing can be used for storage.
TROUBLESHOOTING
PROBLEM CAUSE
SOLUTION
NO
DISPLAY/SPA
CONTROL UNIT
DOES NOT
WORK
-
Spa is unplugged or off.
- Control
panel
cable
plus
loose.
- Power
Failure.
- GFCI/RCD
tripped.
- GFCI/RCD
broke.
-
Ensure the spa is plugged and
switched on.
-
Ensure the control panel cable plug
is firmly attached to the control
base receptacle.
-
Check the power source.
-
Reset the GFCI/RCD.
-
Contact Intex Service Center.
HOUSEHOLD
CIRCUIT
BREAKER
TRIPPED
-
Circuit breaker under rated.
- Overloaded
circuit
breaker.
-
An electrical fault in the
line.
- Ensure
correct
circuit
breaker
rating.
-
Provide a dedicated circuit breaker
feeding the spa electrical outlet
only.
-
Contact a qualify electrician to
correct the electrical fault.
NOT HEATING
PROPERLY
-
Temperature set too low.
- Dirty
filter
cartridge.
- Water
temperature
decreasing during heater
STANDBY mode.
- Heating
element
failed.
-
Increase the temperature and
attach the spa cover.
-
Clean or replace the filter cartridge
in time.
-
If heater is in STANDBY mode,
press the flame button twice to
heat up the water to the set
temperature.
-
Contact Intex Service Center.