![background image](http://html.mh-extra.com/html/intex/purespa-sjb-hs-11/purespa-sjb-hs-11_manual_2081128019.webp)
2016-0685
2017-10-02
cartridge housing assembly back onto the spa tub wall
2. Change the spa water every 2~3 months, or it becomes cloudy and
proper water chemistry
does not clear it up. See “Spa Tub Drainage” and “Spa Tub Cleaning” sections for
details.
3. Use spa chemicals to maintain proper water chemistry. Spa damage resulting from misuse of
chemicals and mismanagement of spa water is not covered by the warranty.
4. All occupants must shower before entering the spa.
Unplug the power cord before cleaning the system. Cover
the water inlet and outlet with the plugs to prevent water
spillage. After completing all maintenance tasks, you must
plug the power cord back in and remove the plugs.
Electrolytic Cell Cleaning
The electrolytic cell has a self cleaning function incorporated into the
electronic control's programming. In most cases this self cleaning action
will keep the cell working at optimum efficiency. In some regions, the SPA
water is hard (high mineral content) which varies depending on the local
water condition, this would cause deposits on the titanium plate and affect
the sanitizing efficiency, so the cell may require periodic manual cleaning.
To maintain maximum performance, we recommend that you open and
visually inspect the electrolytic cell every two weeks for SPA water
(Calcium hardness < 100 ppm) or weekly for SPA water (Calcium
hardness > 350 ppm).
The following steps provide instructions on how to clean the cell.
Inspection and cleaning:
1.
Turn off the spa and unplug the power cord from the electrical socket.
2.
Unscrew the filter cartridge assembly from the spa stub wall, and
use the included plugs
(15 & 23)
to cover the water inlet and outlet
fittings from inside of the spa tub to prevent water from flowing out.
3.
Remove the four screws from the transparent cover using a
Phillips screwdriver (not included) and remove the cover from the
spa control unit.
4.
Unplug the electrolytic cell cord. Unscrew the electrolytic cell nut in a
counter-clockwise motion using the included electrolytic cell nut wrench
(20)
.
5.
Pull out the electrolytic cell and place it in a container, pour kitchen grade
vinegar into the container to soak the titanium plate for about one hour until
no deposits remain.
6.
Remove the electrolytic cell and flush the titanium plate with fresh water.
Be careful: Keep the electrolytic cell receptacle completely dry, do not let it