![background image](http://html.mh-extra.com/html/intex/purespa-sjb-hs-11/purespa-sjb-hs-11_manual_2081128020.webp)
2016-0685
2017-10-02
come into contact with the vinegar and water.
7.
Reverse the above steps to reinstall the electrolytic cell.
NOTE:
Ensure the notch on the electrolytic cell is aligned with the ridge on the electrolytic cell
housing.
The Test Strips can test the “Free Chlorine”, “pH”, “Total Alkalinity” and “Calcium
Hardness” levels at the same time. We recommend that you test the water chemistry
weekly, and maintain the chlorine concentration at 3-5 ppm.
Directions and Use
1.
Dip the entire strip into the water and remove immediately.
2.
Hold the strip level for 15 seconds. Do not shake excess water from the strip.
3.
Now compare the strip pad to the color chart on the packaging label. If necessary, adjust
the chemical level in the spa water. It is very important, to use the proper technique
when testing the water's chemical level. Read and follow the written strip instructions
carefully.
The life expectancy of the electrode is 2000 hours under normal conditions.
Spa Tub Drainage
1.
Turn off and unplug the spa control unit.
2.
Connect the drain valve adaptor to a garden hose and point the other end of the garden
hose to a suitable draining area
(see drawing 12).
3.
Remove the drain valve cap from outside of the spa tub and attach the drain valve
adaptor to the drain valve
(see drawing 12).
4.
From inside of the spa tub, open the drain valve cap, water will start
flowing out
from the garden hose.
5.
When the water stops draining, disconnect the spa control unit from
the spa tub
wall. Lift the spa tub wall from the side opposite the drain, leading any
remaining water to the drain and emptying the spa completely
(see
drawing 13).
6.
Turn over the spa tub to empty any remaining water
(see drawing 14).
7.
Unscrew the drain valve on the spa
control unit side using a coin to drain
out any water
(see drawing 15).
8.
Use a clean towel to wipe up any
remaining water and moisture on the
spa tub and spa control unit.
9.
Ensure the spa tub and spa control unit are thoroughly dried.
NOTE:
The enclosed plugs
(15 & 23)
can be used to cover the water inlet
and outlet
connectors from the inside of the spa tub to prevent water from flowing
out.
Spa Tub Cleaning
If dirt is visible in the water or water
becomes cloudy and proper water
chemistry does not clear it up, change
the water and clean the spa tub. See
“Spa Tub Drainage” section on how to
drain the spa.
While empty, remove the cartridge housing from inside of the spa tub wall, clean and/or
replace the filter cartridge. Use a sponge and mild soap solution to wipe away any soil or
stains on the inside of the spa wall. Rinse thoroughly before refilling with clean water.
IMPORTANT:
Do not use steel wool, hard brushes or abrasive cleaners.