11 / 18
Remote Control Storage Area
z
If the air conditioner will not be used for an extended period of time, remove the batteries from the remote
control.
4. Remote Control Storage
Your air conditioner has a special place for remote control storage. Please always put remote control into
compartment after use.
Note: In order to avoid losing the remote control, please put the remote control inside of the storage place when
you do not use it.
CAUTION
If the liquid from the batteries gets onto your skin or clothes, wash it well with clean water, do not use the remote
control if the batteries have any leakage.
If you eat the liquid from the batteries, brush your teeth and see doctor. The chemicals in batteries could cause
burns or other health hazards.
Multiple Protection Functions
1. Anti-freeze protection function
Compressor, water spraying motor will turn off when compressors running over 10 minutes and tube temperature
(Tp) is continuously
≦
2
℃
for 20 seconds under cooling mode, E4 will show on LED display window, the unit
initiates the anti-frost protection and all buttons on control panel (except for power button) are inactive.
Once the tube temperature
≧
8
℃
, the protection is relieved to recover into original status, and compressor apply
to 3-minute delay protection.
2. Water-full safety alarm and shut
–
off protection function:
Warning sounds when the water volume reached its alarm level in water tank, and unit is automatically stop
working, both water-full indicator and
“
FL
”
on LED window is flashing. You need to drain the condensate for unit to
automatically recover operation. (For more information about how to drain,
refer to the “
Drainage Instruction
”
please).
3. Delay protection function of compressor
This unit offers restart protection to compressor. Except that the compressor may start immediately when the unit
is energized at first time, there is 3-minute start delay after compressor is shut down.
Handling and Transportation
1. Handle and move the unit
Hold the top of the air outlet window in front panel with one hand and the handle at the top of back panel with another
hand, then move the unit in upright position (As shown in Photo below).
Note:
z
Do not hold the horizontal louvers by hand.
z
Make the unit in the upright position whatever handling or moving it.
