Interra ITR504, Product Manual

Page: 33 / 82

Combo Output Module
Product Manual
©2017 INTERRA 33
PM131126001A
PARAMETER DESCRIPTION VALUES
No Reaction/Last State: The output remains the
last value received even thought this value has
been received during the forced.
OFF: The output takes the value 0.
ON: The output takes the value 1.
OFF
ON
Feedback Telegram This parameter is used to set weather the status
output is shown.
Disabled: There is no information about the status
output.
Normal: The real status of the output is shown via
the “status” communication object.
Inverted: The inverted status of the output is
shown via the “status” communication object.
Disabled
Normal
Inverted
Feedback Startup Time Delay
4
This parameter set a delay between the startup
and the sending of the feedback telegram to the
bus.
“Disabled” option means that there is not
emission of the telegram after the startup.
Disabled
5s, 10s, 30s, 1min,
5min,
10min,
20min, 30min,
40min, 50min, 1h.
2h, 3h, 4h, 5h, 6h,
12h, 24h.
Feedback Periodical Sending
4
This parameter determines the sending period of
the output current value. “Disabled” option means
that the feedback telegram is sent only after
output changes, not periodically. Disabled
5s, 10s, 30s, 1min,
5min,
10min,
20min, 30min,
40min, 50min, 1h.
2h, 3h, 4h, 5h, 6h,
12h, 24h.
Behaviour During Bus Voltage
Failure This parameter determines the behaviour of the
output during a bus voltage failure
No Reaction/Last State: There is no reaction; the
output remains the last state.
OFF: The output is switched off.
ON: The output is switched on.
No Reaction/Last
State
OFF
ON
Behaviour After Bus Voltage
Return This parameter determines the behaviour of the
output after a bus voltage failure.
No Reaction/Last State: There is no reaction; the
output remains the last state.
OFF: The output is switched off.
ON: The output is switched on.
No Reaction/Last
State
OFF
ON
1
These parameters are only visible when the parameter “Summer/Winter Mode Switch Over” is set to “Yes”.
2
These parameters are only visible when the parameter “Type of Manipulated Variable” is set to “Continuous
(1 Byte)”.