INSTALLATION INSTRUCTIONS
Gas Furnace: (F/G)9MVE
440 01 4400 03
15
Specifications subject to change without notice.
Figure 10
Unconverted Factory Configuration as viewed in the Horizontal Right Orientation
A11573LA
Remove plug from
collector box.
DO NOT DISCARD.
If alternate vent position
is required, loosen clamp
on inlet of vent elbow.
Remove the screw that secures
the trap to the collector box and
remove trap.
Representative drawing only, some models may vary in appearance.
Horizontal Right Trap Configuration
A11573LB
Attach condensate
trap with screw to
collector box.
Slide relief tube in stand
−
offs
to adjust length.
Vent elbow shown in alternate
orientation. Tighten clamp on
inlet to vent elbow 15 lb.
−
in.
Align trap over middle and
right
−
hand port on collector box.
NOTE: Remove knockout in
casing before re
−
installing the
condensate trap.
Representative drawing only, some models may vary in appearance.
Install plug on
open port of
collector box
