Intermec Janus 2010, User Manual, Page: 133 / 558

NF
BC
Using PC Cards in the Reader
4-7
4
Note: If CS_IPM.EXE is not already loaded, the “Internal Drive Reset After
Battery Change” command and RESET INTERNAL DRIVE AFTER BATTERY
CHANGE parameter have no effect on the reader.
To load CS_IPM.EXE into memory
• CS_IPM.EXE is loaded into memory when you boot the reader because this
command appears in the default AUTOEXEC.BAT file:
d:\cs_ipm.exe
CS_IPM.EXE is stored on drive D and the Application companion disk 3. If
the command is not in your AUTOEXEC.BAT file, type this command at
the DOS prompt:
d:\cs_ipm
Or scan this bar code:
*D/Z%LCS%OIPM*
*D:\CS_IPM*
To use the “Internal Drive Reset After Battery Change” command
• See “Internal Drive Reset After Battery Change” in Chapter 12.
To set the RESET INTERNAL DRIVE AFTER BATTERY CHANGE parameter
1. To start IC.EXE, type this command at the DOS prompt:
ic
Or scan this bar code:
*IC*
*IC*
2. Choose Power Mgmt from the Op menu. This screen appears.
Configuration
Oper/Power Mgmt
AUTO SHUTOFF: 9600
INTERVAL:01
UNITS:MINUTES
RESET INTERNAL
DRIVE AFTER BATTERY
CHANGE:
Do Not Reset Card
OK Cancel
2010U.154