Intermec Janus 2010, User Manual, Page: 108 / 558

JANUS 2010 Hand-Held Computer User’s Manual
3-22
To copy the image file to more than one reader
Note: All the files on each reader’s drive C will be overwritten.
1. Connect the reader to the host computer through a communications dock
or optical link adapter. If you use the communications dock, you must
connect the dock to the host computer with a 3-wire (2, 3, and 7) cable for
Interlnk to operate properly.
2. Connect the power supply to the communications dock or the optical link
adapter.
3. Type the LOADXIMG or LOADIMG command:
• If the image file has the NEWDRV_C\IMAGE\DRIVEC.IMG default
name, type this command on the host computer:
loadximg
• If the image file has any other name, type this command on the host
computer:
loadimg path \ filename
where:
path is the drive and directory of the image file to load.
filename is the name of the image file to load.
For example, to load the FLASH\C-ATA.IMG image file, type this
command on the host computer:
loadimg c:\flash\c-ata.img
4. Auto-Loader runs Intersvr on the host computer. When you see the
Interlnk Server Status screen on the host computer, press
c a f .
to
warm boot the reader and load Interlnk into memory. Auto-Loader begins
updating drive C.
5. When the update is complete, the reader reboots automatically.
6. To load the image file on another reader, disconnect the reader from the
host computer, connect another reader to the host computer, and repeat
Steps 3 through 5.
Note: Interlnk is still loaded in memory on the reader you disconnected from the
host computer. You can press
c a f .
to warm boot the reader and remove
Interlnk from memory.
7. When you finish updating your JANUS readers, you can exit Intersvr on
the host computer by pressing Alt-F4. You will see this message:
Drive C: Installation process completed.