Intermec ESim v4.20, Programmer'S Reference Manual, Page: 20 / 160

14 Intermec EasyCoder ESim v4.20—Programmer’s Reference Manual
Chapter 3—Setting Up the Printer
Default Setup
Parameter Command Default Setting
Error/Status Char. eR 0,0 XOFF/XON-handling
Density D 10 10
Character Set
I 8,0,001
8 bits, code page 0, country code 001
Top of Form backup JF Enabled
Media feed adjust j 136
j 204
136 dots (at 203.2 dpi)
204 dots (at 300 dpi)
Label Gap Sensor O N LTS disabled, TT mode, reverse gap disabled.
cutter disabled
Char. substitution oR No substitution
Form Length
Q 24,0
Continuous mode, print gap 24 dots
Label Width
q 832
q 1208
832 dots (at 203.2 dpi)
1208 dots (at 300 dpi)
Reference Point
R 000,000
X:000;Y000
Print Speed S 2 50 mm/sec. (2 inches/sec.)
Reply Character UC 0 None
Error Handling
UN
Error reporting disabled
Windows Mode W N Disabled
Serial Port Y 96,N,8,1 9600 baud, no parity, 8 data bits, 1 stop bit
Print Direction
Z T
Start printing at top of image buff er
Printhead Resolution Measures
203.2 dpi printheads 203.2 dpi (8 dots/mm) in both directions
300 dpi printheads 300 dpi (11.81 dots/mm) across the media path
304.8 dpi (12 dots/mm) along the media path
Th e setup will be reset to default values if...
• the printer's fi rmware is upgraded using a fi rmware cartridge,
• or the
Feed key is pressed more than 3 seconds in the Dump Mode.