INTERMATIC EI200 ELECTRONIC
IN-WALL COUNTDOWN TIMER
FEATURES:
• 5-10-15-30 - Minute time ranges.
• Continuous HOLD feature.
• Available in White, Ivory, & Light Almond
RATINGS :
15A General Purpose
1000W, Tungsten
1/4 HP Motor
1000 VA, Ballast
125 Vac, 60 Hz
Leads: Black-Line, White-Neutral, Red-Load, Green-Ground
INSTALLATION
1. WARNING: TO AVOID FIRE, SHOCK, OR DEATH, TURN OFF POWER AT CIRCUIT
BREAKER AND TEST THAT POWER IS OFF BEFORE WIRING.
2. Remove wall plate and disconnect light switch. Make sure both “hot” and neutral wires are
present in the junction box. (See Fig. 1.) If both wires are not present, additional wiring will be
necessary before installation can be completed.
3. Connect red timer wire to wire from fixture using
wire connector. Connect black timer wire to the “hot”
(usually black or red) wire in junction box using wire
connector. Cut white wire in junction box (or open
splice) and strip 3/8” of insulation on both wires.
Connect white timer wire to white wires in junction
box using wire connector. (See Fig. 2)
4. If the wall switch you are replacing had separate
grounding conductors connected to the GREEN
screw on the switch, make sure to connect these to
the green wire from the timer with a wire connector.
5. Check that all wire connections are secure.
6. Place all wires inside junction box. Fit timer into
junction box. Next, install timer using (2) mounting
screws furnished.
7. Reconnect your electrical power.
OPERATIONS
Timer Mode
To enter timer mode, press and release the push button (for less than 2 seconds) repeatedly to select one of the four time set-
tings or OFF ( 5 minutes - 10 minutes - 15 minutes - 30 minutes - OFF). The illuminated LED
indicates which time setting is selected and the connected load is turned ON. Timer starts counting down until time out is
reached, all 5 LED’s go off and the connected load turns OFF.
Hold Mode (Continuous Operation)
To turn timer ON for extended periods of time, press and hold the push button for more than 2 seconds. Timer enters HOLD
mode, HOLD LED turns on, and the connected load is turned ON. To exit HOLD mode press and release the push button, all 5
LED’s go off and the connected load turns OFF.
LIMITED 1 YEAR WARRANTY
If within one (1) year from the date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its
sole option, free of charge. This warranty is extended to the original household purchaser only and is not transferable. This warranty does not apply to: (a) damage
to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened,
taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp
bulbs, LED’s and batteries; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit
damage, initial installation costs, removal costs, or reinstallation costs.
INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE
EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO
YOU. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES. ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF
MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN
THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW
LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof
of purchase, postage prepaid to the authorized service center listed below. This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd.,
Spring Grove, Illinois 60081-9698/815-675-7000 http://www.intermatic.com Please be sure to wrap the product securely to avoid shipping damage
.
INTERMATIC INCORPORATED
SPRING GROVE, ILLINOIS 60081-9698
158--00454
“HOT”
(Black or Red)
“NEUTRAL”
(WHITE)
FIGURE 1
WIRE FROM FIXTURE
HOT
FIGURE 2
