2. Select the
Enable
check box to enable the function.
3. Click
Draw Area
. A crossing plane appears on the image.
4. Click the line and two red squares that appear at each end. Drag one of the red
squares to define the arming area.
Select the direction as
A<->B
,
A ->B
, or
B->A
from the drop-down list:
• A<->B:
Only the arrow on the B side is displayed. When an object moves across
the plane in both directions, it is detected and alarms are triggered.
• A->B:
Only an object crossing the pre-defined line from the A to the B side can
be detected and trigger an alarm.
• B->A:
Only an object crossing the pre-defined line from the B to the A side can
be detected and trigger an alarm.
5. Set the sensitivity level between 1 and 100.
6. If required, select another line crossing area to configure from the
Line
drop-down
list and repeat steps 3-5. Up to four line crossing areas can be configured.
7. Click
Save
to save changes.
8. Click the
Arming Schedule
tab to edit the arming schedule. Click and drag along
the time bars or click on a time bar to configure arming schedule times.
Note:
All scheduled times are based on the 24-hour clock. Ensure that the correct
time zone and daylight saving time settings have been configured in
Configuration
>
System
>
System Settings
.
9. Click
to copy the schedule to other days by selecting the corresponding check
box next to the day.
10. Click
Save
to save changes.
11. Click the
Linkage Method
tab to specify the linkage method for when an event
occurs. Select one or more response methods for the system when an alarm is
triggered. See “Linkage methods” on page 31 for details.
12. Click
Save
to save changes.
Schedule settings
Recording schedule
Use the Record Schedule window to define a recording schedule for the camera. The
recording is saved to the SD card or the NAS in the camera. The camera’s SD card
provides a backup in case of network failure.
The selected recording schedule applies to all alarm types.
TruVision 81 Series IP Camera Configuration Manual
41
