11
U
U
5
CHANGING USER CODES
Note: For partitioned systems, someone changing the code of another person must have
access to all or more partitions than the user being changed.
1) Enter [
U
]-[5]
The LCD Screen will prompt for a code.
2) Enter [master code]
The LCD Screen will prompt for a user number.
3) Enter the 2-digit (applies to
NX4/6/8) or 3-digit (NX8E) user
number. Remember to use
leading zeros, i.e. "03" or
003"
for user 3.
The LCD screen will prompt for a new code.
4) Enter the new user code designated for that individual. The sounder will beep 3 times if it
rejects the code.
5) If another user code needs to be programmed, return to step 3.
6) To exit Code Programming, press [#] while the LCD screen is prompting for a new user
number.
U
U
6
ASSIGNING AUTHORITY LEVEL
Note: You must have authority to the partition you wish to add or remove from another
person’s authority.
1) Enter [
U
]-[6]
The LCD Screen will prompt for a code.
2) Enter [master code]
The LCD Screen will prompt for a user number.
3) Enter the 2-digit (applies to
NX4/6/8) or 3-digit (NX8E) user
number. Remember to use
leading zeros, i.e. "03" or
003"
for user 3.
The LCD will now prompt you for the first in the following
list of attributes.
PROMPTS
(#1) Outputs used?
Open / Close Rprt?
Bypass enable?
Arm / Disarm?
If Prompt #1 ("Outputs used?") is
answered NO, the LCD will
display the four messages below.
If Prompt #1 ("Outputs used?") is
answered YES, the LCD will
display the four messages below.
Master code?
Output 4 enable?
Sched arm only?
Output 3 enable?
Arm only?
Output 2 enable?
Reserved
Output 1 enable?
4) Enter a partition number. NOTE: The default allows access to all partitions. The first
keypress will remove access to the partition. To reestablish access, press the partition
number again.
5) Press [
U
] when completed.
The LCD Screen will prompt you for the next user code.
6) If another user code needs to be programmed, return to Step 3.
7) To exit this feature, press [#].
NOTE TO INSTALLER: Any master arm/disarm code can add or change a user code if
the master code has access to the same partitions as the code being added/changed.
Consequently, when programming the user codes for a partitioned system, leave at
least one code access to all partitions or you will not be able to add new users (can be
"go to program code" if enabled in location 43 of the control panel). If you desire the
end user to be able to add new codes, you must remove the partition authority from all
blank codes.
