Interlogix FlexZone Series, Product Manual

Page: 49 / 104

Chapter 2: Installation
FlexZone™ Product Guide
43
• If razor ribbon is installed along the bottom of the fence, mount the processor
on the secure side of the perimeter, away from the fence and razor ribbon.
Caution: For installations in environments which include hot sunny periods, it is
recommended that a sun shield be installed to protect the enclosure from direct
sunlight, or that the enclosure be installed in a shady area. The maximum
operating temperature, as measured inside the enclosure, is 70
º C (158º F).
Figure 50: FlexZone single pass dual zone fence-mounted processor
1. Hold the enclosure against the fence at the specified installation location.
2. Feed the end of the gear clamp through an upper flange slot, around the
fence post, and back through the second slot.
3. Insert the end of the gear clamp into the gear mechanism and tighten the
screw.
4. Repeat this with the second gear clamp on the lower flange at the bottom of
the enclosure.
A-side cable
B-side cable
processor/enclosure
upper gear clamp