TruVision HD-TVI Series 4 PTZ Dome Camera Configuration Manual
5
Configuration
This section describes how to set up the menu settings.
System Info
Display the current system information of the PTZ dome, including model,
address, protocol, etc.
Note:
Information on this menu cannot be edited.
The temperature refers to the internal temperature of the PTZ dome.
Dome Settings
System Settings
You can check and edit the system information of the software address, baud
rate, system time, etc. on the system information settings menu.
Note:
Click the left and right directional buttons in the PTZ control panel via the
web browser of the encoder to enter the next page and return to the previous
page of the submenu if more than one page is available.
Note:
As TruVision recorders do not support an address greater than 255, a soft
address greater than 255 will not support any protocol even though the camera
supports 8190 for UTC-RS485 (Interlogix-Protocol) and 512 for DIGIPLEX and
ASCII. However, you can have an address greater than 255 for legacy products
that supports UTC-RS-485 (Interlogix-Protocol), DIGIPLEX or ASCII.
SOFT ADDRESS
This is the address to connect and control the HD-TVI PTZ dome. It
can be used as an alternative to the hard address if, for example, the
address must be above the available hard address.
SET SOFT
ADDRESS
ON
: The soft address is the valid address for the HD-TVI PTZ dome.
The selectable soft address range is from 1 to 255.
OFF
: This refers to the hard address. Use the DIP switch to set the
valid address for the HD-TVI PTZ dome.
SOFT BAUDRATE
This is the valid baud rate for the HD-TVI PTZ dome with the soft
address.
