3
Installing the Hardware
You will set up the components of the ImageStation Z hardware and software in the following order:
1. Cyborg
chair
2. Monitor
table
3. D-sized digitizer table
4. TDZ workstation base unit and keyboard
5. Monitor
6. Interface peripheral equipment module (PEM), two-handed controller, and cabling
7. Stereoscopic display subsystem
8. All power cords and setting switches
9. Altek and StudioZ Producer drivers
Detailed instructions for setting up these components are covered in the remainder of the document.
Equipment Cautions
Note the following cautions when installing and using ImageStation Z hardware:
u
The digitizer table work surface is a non-load bearing surface. Damage to sensitive parts may
occur if used for purposes other than intended.
WARNING
Do not sit or lean on the digitizer table during or after assembly. Failure to heed this warning
may result in equipment damage.
u
The stereoscopic glasses are fragile. Handle them carefully. When not in use, store the glasses in
the box they came in or another suitable container.
u
Do not immerse the stereoscopic glasses in water or other liquids. Consult the documentation
delivered with the glasses for more information on the care and cleaning of the glasses.
Assemble the Cyborg Chair
To assemble the Cyborg chair:
1. Remove the installation/assembly instructions from the packing box and review them.
2. Remove the Chair Base/Casters assembly from the packing box and place it on the floor with the
casters down.
3. Remove the Chair Seat/Arms assembly from the packing box.
4. Insert the Chair Seat/Arms assembly post into the center hole of the Chair Base/Casters assembly.
Apply firm, even pressure to seat the post into the Base/Caster assembly.
Summary of Contents for ImageStation Z and use
Page 1: ...ImageStation Z Installation and Use August 1997 DHA023320 ...
Page 4: ......
Page 24: ...20 ...
