9330 Operating Manual
Interface Inc.
● 7401 East Butherus Drive, Scottsdale, Arizona 85260 USA ● Phone 480.948.5555 ● Fax 480.948.1924
www.interfaceforce.com
● Email:
●
800.947.5598
Document Number 15-216 Rev B
Page 22 of 74
Power Supply per USB Connection
If the USB power supply “USB Power” is activated in the logger menu, the device can also be
powered via the USB port if it is connected to a host PC and fully configured. The battery is emptied
barely or not at all when switched on. When the device is switched off, the battery can be charged by
the host PC. In this state, the device is then an SD card reader, irrespective of the set USB mode.1 A
USB charging device cannot be used at this time.
USB Driver
The USB Mass Storage mode does not need a driver for Windows systems from Windows XP - once
the USB cable is connected a window will appear (depending on operating system settings), where
you can access the files; or you can reach the 9330 drive via “My computer” or with the Windows
explorer.
BlueDAQ Software Installation
1.
Please follow these instructions carefully.
DO NOT
connect the amplifier to the PC until
instructed to do so. The BlueDAQ PC software is included on a USB Flash Drive with the amplifier
or can be downloaded from
www.interfaceforce.com
2. Install the software by double-
clicking the “setup.exe” file located in the BlueDAQ folder. You may
need to “Extract” the contents of the folder first if you downloaded it from the website. Follow the
instructions for installation. Once the software completes installation you
MUST
restart your
computer.
3. Attach the amplifier to the PC using the supplied USB A-B cable. BSC4, BSC8 and BX8 drivers
were installed with the BlueDAQ software and Windows will automatically load them. BSC8D/BX8
must be powered ON using supplied power cable and power switch. 9330 drivers must be
installed as described below.
4.
When the device is connected in
Communication mode
for the first time, Windows will ask for a
driver directory. The installation process is described below. The driver is located on the USB
Flash drive supplied with the 9330. The Flash drive
MUST
be connected to the PC or the files
copied to the PC before connecting the 9330 to the PC.
5.
Enable USB Communication mode. To do this, click the MODE button of the measuring amplifier
and select USBmode: Comm in the logger menu.
