9330 Operating Manual
Interface Inc.
● 7401 East Butherus Drive, Scottsdale, Arizona 85260 USA ● Phone 480.948.5555 ● Fax 480.948.1924
www.interfaceforce.com
● Email:
●
800.947.5598
Document Number 15-216 Rev B
Page 19 of 74
Description of the Buttons
Button
Function
MODE
To switch on and off or access the Logger menu
MENU
(LEFT)
To access the measuring amplifier menu, to go one menu level higher or to cancel an
entry.
For numeric settings: to move the cursor left.
UP
To move around the menu within the same level: switching to the next entry.
For measured value mode=MaxMin: to switch from one measured value display to the
next one up.
For numeric settings: to increase number and/or setting above the cursor.
DOWN
To move around the menu within the same level: switching to the previous entry.
For measured value mode=MaxMin: To switch from one measured value display to the
next one down.
For numeric settings: to decrease number and/or setting above the cursor.
OK
(RIGHT)
To confirm the entry or move down one level.
For measured value display and recording mode “with OK”: to record measured values
to file.
For numeric settings: to move the cursor right.
SHORT
To connect the +Ud and -Ud inputs (short-circuit of sensor signal)
ZERO
To trigger an automatic zero adjustment.
Number Setting
To set a numerical value and the date or time, move the cursor right by pressing OK and left
by pressing MENU. The digit (and/or the month) above the cursor flashes and can be
increased or decreased using the UP / DOWN buttons.
For the setting to take effect, the OK button must be held down until the whole number flashes.
Then release the OK button, and the following message will appear “OK to confirm“. Confirm
this by pressing OK. To cancel the numeric setting, hold down the MENU button.
Description of LEDs
LED
Meaning
ON
Permanently on: Device on, no charging. Flashing slowly: Device off, battery charging.
Flashing faster: Device on, battery charging.
CARD
USB mass storage device active.
COM
USB serial communication mode active.
LOG
Measured data recording to SD card active.
Do not remove card!
ERR
An error has occurred. Flashes permanently after switching on: the battery was empty,
therefore the date and time must be reset. Flashes alternately with ON after switching on
for approximately 3 seconds: the battery is empty, please connect power adapter to
charge. Flashes alternately with LOG: an error occurred whilst attempting to record
measured data e.g. the SD card may be write protected, full, incompatible or defective.
