B Y O S 1 L I A B I L I T Y D I S C L A I M E R
i
BYOS-IM Rev. 08/15 (SBK-BYOS INSTAL)
3050 S. Alvernon Way • Tucson, AZ 85713
520.790.7040 • 800.737.5386 • Fax 520.790.7127 • inter-fab.com
IMPORTANT NOTICES
LIABILITY DISCLAIMER: This BYOS product provides the customer the opportunity to
design a one-of-a-kind slide, unique to the customer’s preferences. When purchasing this
BYOS product, the customer acknowledges and agrees that he or she has designed and
created the specifications for this product. S.R.Smith makes no claims, representations
or warranties, whether expressed or implied, regarding this design of this product, or
this product’s safety, relability, durability, or performance. In no event shall S.R.Smith
be liable for any direct, indirect, punitive, incidental, special, or consequential damages
arizing out of or connected with the use or misuse of this product.
Inter-Fab recommends that you read the BYOS 1 Installation Manual in its entirety before attempting
an installation.
• It is highly recommended that provision be made for future maintenance and/or removal of the
slide from the substrate, if necessary. Do not fully encase the slide in concrete or pernanently
fixed structure/material.
• Do not construct objects or formations along or over the slide pathyway that obstruct the
pathway for sliders or cause potential harm to the head, arms or legs.
• Minimum recommended head clearance above the slide pathway is 7 feet.
• Minimum BYOS 1 water envelope is 7’ wide (centered on slide) x 13.5’ long x 4.5’ deep
.
• The exit section must be installed with the correct alighnmenet to the pool edge with a
minimum overhang of 3” and should be supported at the fiberglass landing plate.
• Zoom Flume™ water delivery system requires a 1” PVC flex hose. For best performance,
the recommended water flow at the slide is 20-40 GPM, connecting a ball valve in line is
recommended for water flow adjustment. NOTE: Connect the Zoom Flume™ water
delivery system to water source and test for leaks or defects prior to final assembly/
installation.
• See page 16 of installation manual for BYOS 1 Care and Maintenance.
•
FAILURE TO INSTALL BYOS 1 PRODUCTS SO THAT THE ENTRY SECTION SUPPORT
FRAME IS LEVEL, WILL CAUSE THE DESIGN TO EXCEED THE RECOMMENDED
ANGLE OF DESCENT AND MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE. NO INSTALLED BYOS 1 SLIDE SHOULD EXCEED A 20 DEGREE SLOPE.
•
FAILURE TO INSTALL THE BYOS 1 SLIDE ANCHOR SYSTEM TO THE MINIMUM
DEPTH SPECIFIED IN THE INSTALLATION INSTRUCTIONS OR ALTERATION OF THE
BYOS 1 SLIDE ANCHOR SYSTEM WILL CAUSE STRUCTURAL INSTABILITY AND MAY
RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE.
•
DO NOT DRILL INTO OR THROUGH ANY BYOS SLIDE SECTION OR ANCHOR OR
OTHERWISE MODIFY. IT WILL WEAKEN THE PART AND VOID THE WARRANTY.
WARNING
