Intellinet 523868, User Manual

Page: 44 / 56

all aggregated port sets.
CLI Syntax: clear lacp counters [STACKID]
Example: clear lacp counters 1
2.3.3.12.2 LACP Aggregation-Link Trunk
This command sets the link Aggregation Control Protocol (lACP) operation add/set for the
trunk group ports on the switch.
CLI Syntax: lacp aggregation-link trunk STACKID (add/set) group <1-32> PORTLIST
Example: SWITCH# lacp aggregation-link trunk 1 set group 1 1,2
2.3.3.12.3 Disable LACP Aggregation-Link Trunk
This command sets the link Aggregation Control Protocol (lACP) operation add/set or disable
for the trunk group ports on the switch.
CLI Syntax: lacp aggregation-link trunk STACKID disable <1-12>
Example: SWITCH# lacp aggregation-link trunk 1 disable 2
2.3.3.12.4 LACP Port-Priority
This command sets the port priority for the link Aggregation Control Protocol (lACP) on the
switch.
CLI Syntax: lacp port-priority <1-65535>
Example: (config)# interface fa1/0/2
(config-if)# lacp port-priority 1000
2.3.3.12.5 LACP System-Priority
This sets the system priority for the link Aggregation Control Protocol (lACP) on the switch.
CLI Syntax: lacp system-priority <1-65535>
Example: (config)# lacp system-priority 20000
2.3.3.13 Mirroring
2.3.3.13.1 Mirror Mode
To set the port mirror mode.
CLI Syntax: mirror mode
Example: (config)# mirror mode l2
2.3.3.13.2 Mirror Setting
This command mirrors the source interface list traffic to the destination interface. The mirror
type supports received traffic, transmitted traffic or both.
CLI Syntax: mirror IFLIST to IFNAME (rx|tx|both)
Example: (config)# mirror gi1/0/3-5 to gi1/0/9 both
2.3.3.13.3 Show Mirror
To show current mirror features.
CLI Syntax: Show mirror
Example: SWITCH# show mirror
2.3.3.13.4 No Mirror
This command resets the source interface’s received or transmitted traffic or both to the
destination interface.
CLI Syntax: no mirror SRCIFLIST (rx|tx|both)
Example: (config)# no mirror gi1/0/1,gi1/0/4 rx
2.3.3.14 Static Multicast
2.3.3.14.1 MAC-Address-Table Multicast
Use the mac-address-table multicast configuration command on the switch to add multicast
static addresses to the MAC address table.
CLI Syntax: mac-address-table multicast MACADDR vlan VLANID interface IFLIST
Example: (config)# mac-address-table multicast 0100.5e11.1111 vlan 2 interface gi1/0/3 1
44
COMMAND LINE INTERFACE