Intellinet 509060, User Manual

Page: 38 / 76

If you manually disable the wireless function, the print server’s wireless lAN will be
always disabled and ethernet will be always enabled. You also can select “Auto” to
let the print server automatically decide to enable or disable the wireless function.
The print server only can work in ether ethernet or wireless lAN mode: It cannot
work in both ethernet and wireless lAN mode at the same time. When the print
server starts up, it will auto-detect if the lAN port is connected to an active network
by an ethernet cable. If the print server is connected to an active network through
an ethernet cable when starting up, the print server will run in ethernet mode. If
the print server is not connected to an active network by ethernet cable when
starting up, the print server will run in wireless lAN mode. The print server default
is in “Auto” mode.
domain country: The wireless channels vary from country to country. Generally,
the channels are from 1 to 11 in the U.S. and from 1 to 13 in europe. The operating
channel will be set to the print server before importing. If you are in a different
locale, make sure that you have set the available channels according to your
location.
7.13 Wireless Configuration
If you want to use the print server through a wireless lAN, set up the print server
through Ethernet first and make sure your wireless LAN setting is correct. After
setting the wireless lAN, unplug the ethernet cable and restart the print server;
then you can start to use the print server through the wireless lAN. NOTE: If the
wireless configuration doesn’t work, plug the Ethernet cable in again, restart the
print server and configure the print server through Ethernet until the wireless LAN
settings are correct.
The default settings of the print server wireless function are as follows.
• Mode: Infrastructure
• SSId: default
• Channel: 11
38
CONFIGURATION UTILITY