CC Number
(0 - 95)
Selects which MIDI CC# is the source of the control voltage
sent out the device’s
CC
[G]
jack. For example, if you select
5 Portamento Time
, then the
CC
[G]
out jack will transmit
a control voltage based on CC #5 data from your MIDI
source. CC #2 (Breath Controller) is the factory default.
NOTE: Not every value between 0 and 95 is available. Those
that aren’t are greyed out. Note also, that if the Output Type
= CC Number (High Resolution) , then fewer CC sources
are available than if Output Type = CC Number .
CV Polarity
Unipolar
The
CC
[G]
jack outputs a unipolar signal ranging from 0V to
+5V. MIDI 1U interprets the incoming MIDI CC data as a
unipolar signal, meaning a CC value of 0 maps to 0V and a
CC value of 127 maps to +5V. This is the factory default.
Bipolar
The
CC
[G]
jack outputs a bipolar signal ranging from -5V to
+5V. MIDI 1U interprets the incoming MIDI CC data as a
bipolar signal, meaning a CC value of 64 maps to 0V. Values
less than 64 map to negative voltages (with a CC value of 0
generating -5V). Values greater than 64 map to positive
voltages (with a CC value of 127 generating +5V).
MOD Output Settings:
Use these settings to configure the source and type of signal sent from the
MOD
[D]
jack (applies
only to Normal Mode, since the
MOD
jack is used for CH B’s PITCH output in
).
The
MOD Output
parameters are identical to those described for the
CC Output
, above.
Reset above to Defaults
:
Click this button to reset the MIDI 1U to its factory default settings.
Configuring the MIDI Expander 1U Module
The MIDI Expander 1U is not yet available. This manual will be updated when it is.
Once available, this section will describe how to use the
Intellijel Config
app to customize the jack
assignments on a MIDI Expander 1U module.
MIDI 1U System Manual
24
