both ends and that all the pins are correctly aligned. If the pins are misaligned in any direction or the
ribbon is backwards you can cause damage to your module, power supply, or other modules.
After you have confirmed all the connections, you can reconnect the power cable and turn on your
modular system. You should immediately check that all your modules have powered on and are
functioning correctly. If you notice any anomalies, turn your system off immediately and check your
cabling for mistakes.
Connecting the MIDI 1U to a MIDI IN Jacks 1U
You will need to connect the MIDI 1U to either a MIDI IN Jacks 1U module or to a case with built-in
MIDI/USB jacks. This section discusses how to connect the MIDI 1U to the MIDI IN Jacks 1U
module.
1.
Turn off power to the case.
2.
Connect the supplied 10-pin-to-16-pin power cable between the MIDI 1U and one of the Case’s
16-pin power connectors (as discussed previously).
3.
Connect one end of the supplied 10-pin to 10-pin ribbon cable to the shrouded 10-pin port on
the MIDI 1U module. The connector is keyed, and will fit in only one direction.
4.
Connect the other end of the cable to the MIDI IN Jacks module.
Pay particular attention to the orientation (aligning the red wire with the white stripe on the circuit
board).
MIDI 1U System Manual
7
