Dual Mode
MIDI 1U offers an alternate, dual channel mode that reconfigures the jacks for 2-channel operation.
In this mode, you have independent MIDI control of the pitch, gate and velocity for two different
MIDI channels (repurposing the
MOD
,
CC
and
TRIG
jacks for
PITCH
,
VEL
and
GATE
jacks,
respectively, for CH B). Also, you will need to configure any desired
CLK
division before entering
Dual Mode.
To enter Dual Mode:
1.
Long press (>1.5 sec) the
LEARN
button.
MIDI 1U reconfigures as a dual channel
device, and the jacks take on the
functions indicated in the graphic to the
right.
Both the
CLK ÷
and
LEARN
buttons glow
yellow
, indicating the device is in Dual
Mode.
To Learn MIDI Channels:
1.
Press the
LEARN
button to prepare for
learning CH A.
The
LEARN
button will turn
red
, and the
CLK ÷
button will extinguish.
2.
Send any channel-based MIDI message into the MIDI 1U.
CH A automatically sets itself to the sent message’s MIDI channel.
NOTE: By default, CH A is set to the same MIDI channel used by Normal Mode. So, if you’re
happy with that selection, you don’t need to learn CH A’s channel, and can proceed to learning
CH B, as described below.
3.
Press the
LEARN
button again to prepare for learning the CH B.
The
LEARN
button will
flash red
, and the
CLK ÷
button will remain off.
4.
Send any channel-based MIDI message into the MIDI 1U.
CH B automatically sets itself to the sent message’s MIDI channel, and the
LEARN
button will
stop flashing, and the unit will return to Dual Mode (both buttons lit
yellow
).
NOTE: MIDI 1U will automatically save any new configuration after 2 seconds of MIDI activity
(both buttons flash
green
), ensuring it returns to exactly the same state after a power cycle.
MIDI 1U System Manual
18
