Intellian v240C, Installation And Operation Manual

Page: 119 / 177

119
Aptus
®
- GPS: displays and sets current antenna’s GPS.
- Heading: displays and sets current ship’s heading information.
· Heading Device: None / NMEA/ NMEA 2000/Ground Test.
The baud rate (4800/ 9600/ 19200/ 38400) must be set if NMEA is selected.
- Bow Information:
displays and sets current antenna’s bow.
- Skew: displays current antenna’s skew and skew offset.
· Pol Sensor Calibration: calibrates the sensor (potentiometer).
· Reset Mechanical Skew Offset: the mechanical skew offset is preset in
the factory with a default value (0, 1, or 2) depending on the assembly
status. Resetting of the mechanical skew offset may be required when
the satellite skew offset is unknown Consolidated Skew Offset=
satellite skew mechanical skew offset). Due to each satellite has
its own skew offset, Intellian recommends you check with your service
provider or satellite operator to get the satellite skew offset value and
input it in Satellite Work Tab rather than resetting the mechanical skew
offset directly.
- Antenna Angle:
displays and sets current antenna’s absolute and relative AZ
(azimuth) position, EL (elevation) position and LNB Pol angle. You can move
antenna azimuth and elevation position and LNB Pol angle by using the arrows or
inputting a value to find the desired satellite manually.
- Use Bluetooth: The data communication between the ACU and the antenna will
be terminated once the Bluetooth function is activated. The built-in Bluetooth
connection module inside of the antenna dome can enable a PC connection right
alongside the dome.
· Modem Lock: turns on/off the Modem lock signal sent from your PC/
laptop to the antenna while Bluetooth is in use.
· Heading Connect: turns on/off the heading signal sent from your PC/
laptop to the antenna while Bluetooth is in use.