Intel SBX44 - Server Compute Blade, Installation And User Manual

Page: 44 / 92

32
Intel® Server Compute Blade SBX44: Installation and User’s Guide
Complete the following steps to install an I/O expansion option:
1.
Review the information in “General Safety” and “Electrical Safety” beginning on page vi and
“Installation guidelines” on page 19.
2.
Shut down the operating system, turn off the blade server, and remove the blade server from the
system chassis (see “Removing the blade server from the system chassis” on page 19 for
information).
3.
Carefully lay the blade server on a flat, non-conductive surface.
4.
Open the cover (see “Opening the blade server cover” on page 20 for instructions).
5.
If an IDE hard disk drive is in IDE connector 2, remove the drive and tray (save the screws that
secured the tray to the system board); otherwise, remove the two screws (A) near IDE connector
2 that secure the system board to the chassis, as shown in the illustration.
6.
Install the I/O expansion option:
a.
Install the I/O expansion option tray (B). Secure the tray to the system board with the screws
from the option kit, as shown in the illustration.
b.
Orient the I/O expansion option as shown in the illustration.
c.
Slide the notch in the narrow end of the option (C) into the raised hook on the tray; then,
gently pivot the wide end of the option into the I/O expansion option connectors, as shown
in the illustration.
✏
NOTE
For device driver and configuration information to complete the installation of the I/O
TP00441
E
D
A
C
B