Intel® Server Board S2600TP and Intel® Compute Module HNS2600TP Product Family
15
2.4.3
Installing the Processor Heatsink
Caution:
The processor heatsink for CPU1 and CPU2 is different. FXXCA91X91HS is for CPU1, while
FXXEA91X91HS2 is for CPU2. Mislocating the heatsink will cause serious thermal damage.
1.
If present, remove the protective film covering the Thermal Interface Material on the bottom side of the
heatsink (see letter
A
).
2.
Align the heatsink fins to the front and back of the chassis for correct airflow. The airflow goes from
front-to-back of the chassis (see letter
B
).
3.
Each heatsink has four captive fasteners and should be tightened in a diagonal manner using the
following procedure:
4.
Using a #2 Phillips* screwdriver, start with screw 1 and engage screw threads by giving it two rotations
and stop (see letter
C
). (Do not fully tighten.)
5.
Proceed to screw 2 and engage screw threads by giving it two rotations and stop (see letter
D
). Similarly,
engage screws 3 and 4.
6.
Repeat steps C and D by giving each screw two rotations each time until each screw is lightly tightened
up to a maximum of 8 inch-lbs torque (see letter
E
).
Figure 22.
Installing the Processor Heatsink
2.4.4
Removing the Processor
1.
Remove the processor heatsink. See
Removing the Processor Heatsink
2.
Unlatch the CPU Load Plate. See
3.
4.
Remove the processor by carefully lifting it out of the socket, taking care NOT to drop the processor and
not touching any pins inside the socket.
5.
Install the socket cover if a replacement processor is not going to be installed.
