91
Setup Men
u
Hardware Setup
In this section, you will perform the initial settings for the following scenarios.
• When you want to change the RDC-7.1’s remote control ID.
• When you want to fix the TV Format setting to PAL or NTSC.
• When you want to fix the AM Frequency Step setting to 9 kHz or 10 kHz.
Remote ID
This section explains how to change the RDC-7.1’s
remote control ID. You may need to change this if the
RDC-7.1’s remote controller interferes with other
IntegraRESEARCH components located in the same
room. You can select 1, 2, or 3 for remote control ID.
If you change the RDC-7.1’s remote control ID, be sure
to select the same ID for the remote controller (See page
142). The default ID for both the RDC-7.1 and remote
controller is 1.
Note:
It is recommended that you perform setup using the
[Setup]/[
]/[
]/[
]/[
]/[Exit] buttons of the
RDC-7.1’s front panel. If the remote controller is used
for setup, signals from the remote controller will not be
received just after the remote control ID settings have
been changed (See “Changing the Remote Controller’s
Control ID” on page 142 to change the remote control
ID for the remote controller).
TV Format (for all models other than USA and
Canadian models)
The settings in the TV Format sub-menu can be
configured for Main B and Zone 2 as well as for Main A.
When you want to reconfigure the settings to conform
to the television format used in the area where you use
the RDC-7.1, use this sub-menu so that no time is
wasted on detection.
Auto:
This is the default setting. When you leave this
setting unchanged, the television format is detected and
automatically set by the RDC-7.1.
PAL:
Use this setting when you know the television
format is PAL.
NTSC:
Use this setting when you know the television
format is NTSC.
Frequency Step
The setting in this sub-menu determines the incremental
or decremental amount when adjusting the AM tuner
frequency. The initial setting is 9 kHz, and this only
needs to be changed if you are using the RDC-7.1 in a
10 kHz region.
9 kHz:
Select if 9 kHz increments are used in your area.
10 kHz:
Select if 10 kHz increments are used in your
area.
Remote Control Setup Sub-menu
TV Format Sub-menu
AM Frequency Setup Sub-menu
(Asian and Australian Models Only)
