Integra DTR-70.3, Instruction Manual

Page: 72 / 108

72
En
■
Operating on the AV receiver
■
Operating on the remote controller
To control Zone 2/3/4, you must press the remote
controller’s
Zone
first.
Zone turns red while Zone 2 is on, and green while
Zone 3 is on, and amber while Zone 4 is on.
Adjusting the Volume for Zones
■
Operating on the remote controller
■
Operating on the AV receiver
If your Zone 2/3 speakers are connected to a receiver or
integrated amp in Zone 2/3, use its volume control to
adjust the volume.
Tip
• The Zone 2/3 volume, tone, and balance functions have no effect
on ZONE 2/3 PRE/LINE OUT when the “ Zone 2 Out ” or
“ Zone 3 Out ” setting is set to “ Fixed ” (
➔
page 63 ).
Muting Zones
■
Operating on the remote controller
Tip
• To unmute, press Zone followed by Muting again. Zones can
also be unmuted by adjusting the volume.
Controlling Zone 2/3/4 Components
1
To turn on Zone 2/3/4 and select an input source,
press
Zone 2 , Zone 3 , or Zone 4 followed by an
input selector button within 8 seconds.
Zone 2/3/4 turns on, the Z2/Z3/Z4 indicator lights on
the display.
Tip
• The corresponding trigger output goes high (+12 V).
To select AM or FM, press Tuner input selector and
Zone 2 , Zone 3 , or Zone 4 repeatedly.
To select the same source as the main room’s, press
Zone 2 , Zone 3 , or Zone 4 twice. “ Z2 Selector:
Source ”, “ Zone 3 Selector: Source ”, or “ Zone 4
Selector: Source ” appears on the display.
2
To turn off Zone 2/3/4, press
Off
for each Zone.
The zone is turned off, and the Z2/Z3/Z4 indicator
goes off.
Tip
• The corresponding trigger output goes low (0 volts).
Input selector buttons
Zone 2 , Off
Zone 3 , Off
Zone 4 , Off
Zone Level
w
/
q
Tone
–/+
8 Receiver
Muting
VOL
q
/
w
Zone
Input selector buttons
1
Press Zone repeatedly, then point the remote
controller at the AV receiver and press
8
Receiver .
Zone 2/3/4 turns on, the Z2/Z3/Z4 indicator lights on
the display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2/3/4, press
Zone repeatedly, followed by Input Selector .
To select AM or FM, press the
Tuner
input selector
and
Zone
repeatedly.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2/3/4. The same AM/FM radio
station will be heard in each room.
3
To turn off Zone 2/3/4, press Zone repeatedly,
followed by
8
Receiver .
Tip
• The corresponding trigger output goes low (0 volts).
1
Press Zone repeatedly.
2
Use VOL
q
/
w
to adjust the volume.
1 Press Zone 2 , Zone 3 , or Zone 4 (the Z2/Z3/Z4
indicator on the display flash).
2
Use
Zone Level w
/
q
within 8 seconds to adjust the
volume.
1
Press Zone repeatedly, and then press Muting .