Names and functions of parts
10
Rear
REMOTE CONTROL jack:
An Onkyo product with
RI jack can be connected and synchronized with this
unit.
FM 75
h
and AM ANTENNA terminals:
The supplied
antennas are connected.
ETHERNET port:
Connect to the router with an
Ethernet cable.
IR IN A/B, IR OUT jacks:
Connected to the multi-room
remote control kit. (*)
12V TRIGGER OUT A/B/C jacks:
Allows you to
connect a device with trigger input jack to enable
power link operation between the device and the unit.
(*)
RS232 port:
Connected to the home control system.
(*)
*
Special devices or cable connections are necessary to use the
control functions
to
. Contact the specialized stores for
more information.
Wireless antenna:
Used for Wi-Fi connection or when
using a
Bluetooth
enabled device. Adjust their angles
according to the connection status.
AC INLET terminal:
The supplied power cord is
connected. Always connect the power cord to an AC
outlet only after connecting it to the AC INLET terminal
of the unit. Disconnect the power cord only after
putting the unit into standby mode. To avoid electrical
shock, always disconnect the power cord from the AC
outlet before disconnecting the other end.
*
Turning on the unit may cause a momentary power surge that
might interfere with other electrical equipment on the same
circuit. If this is a problem, plug the unit into a different branch
circuit.
DIGITAL IN OPTICAL/COAXIAL terminals:
Connected to players. Use a digital optical cable or
digital coaxial cable for connection with the digital
audio output jack of a player.
GND terminal:
Connect if the record player has a
ground wire.
LINE IN terminals:
Connected to players. Use an
RCA cable for connection with the LINE OUT terminal
of a player.
LINE OUT terminals:
Use when connecting recording
devices, such as a cassette tape deck. Use an RCA
cable to connect to the LINE IN terminal on a recording
device.
PRE OUT jacks:
Connect a power amplifier.
SUBWOOFER jack:
Connect a subwoofer with built-in
amplifier to amplify bass output.
ZONE 2 PRE OUT L/R/SUBWOOFER terminals:
Audio output jack connected to a pre-main amplifier, a
power amplifier or a subwoofer with built-in amplifier
for multi-zone playback in a separate room.
SPEAKERS A/B terminals:
You can connect a set of
left and right speakers to each of the A/B terminals.
90°
90°
180°
90°
180°
90°
DTM40.7_mst.book 10 ページ ２０１５年７月２４日 金曜日 午後１２時５８分
