CombiLock 200 simplex / pro / pro RFID
INSYS locks
71
Manual V.1.10
7.2.5
Mounting the Attachment Ring
Mount the attachment ring for keypad CombiControl according to the illustration.
In order to do this, if required,
drill 4 M4 threaded holes,
and, if not carried out already
(see section 7.2.1 above):
drill 1 bore for spindle variant B,
Ø min. 10.5
–
max. 13 mm
(11 mm in ill. to the right)
or
drill 1 bore for spindle variant A,
Ø min. 8.2 mm, max. 12 mm
into the safe door.
After that, with four M4x8 machine screws fasten
the attachment ring with a max. torque of 1 Nm
ensuring that there is no damage in the area
where the ring is secured.
Keypad centre axis is congruent
with lock centre axis.
7.2.6
Mounting the Keypad
Mount the keypad onto the attachment ring at an angle of about 20
o
and after-
wards rotate the keypad clockwise to the right until it fits. See illustrations above.
With the keypad aligned in vertical direction, it is not released, but blocked.
In order to release the keypad (to change keypads, for example), open it first (see
section
on page 65) and release it (see section
on page 72).
Attachment ring for keypad
ca. 20
°
Tastatur unter einem Winkel
von ca. 20° auf den Befestigungsring
aufstecken und anschließend durch
Drehung nach rechts in
Position bringen.
diese
Click