CombiLock 200 simplex / pro / pro RFID
INSYS locks
65
Manual V.1.10
6.2
Special Signals CombiLock 200 RFID
Optical and acoustic signal output during PIN- and code input
Q
Red LED signal after the PIN has been
entered.
Lock is closed:
•
A timer program is active.
•
Lock has been disabled by
the master user.
•
Lock has been disabled by
the connected burglar alarm
system.
p
12 tone signal after the code has been
entered.
Invalid code entered.
Enter PIN and code again.
p
12 tone signal after the RFID-
transponder PIN has been read.
•
Wrong RFID transponder
•
RFID transponder cannot be
read.
Green LED
Q
flashes every second.
Open the electronic lock within
10 seconds by rotating the keypad.
We shall not accept any liability for functional disruptions caused by incorrect operation
or the use of force or improper treatment or for damage to materials or property that is,
for example, attributable to not locking the safe properly.
In case the safe does not open even though you have proceeded correctly
according to the present instructions, please contact the manufacturer of the safe.
6.3
Maintenance
Within typical office environment, the lock system is maintenance-free. Do not use
lubricants or any other substances on or in the electronic lock.
With battery operation,
change batteries
when battery signal is emitted. In order
to change batteries, open the keypad.
Opening the Keypad
In order to open keypad CombiControl CL38, insert the opener
(within scope of delivery) into the boring on top of the keypad
(see figure) and employing well dosed power press it downwards
and to the front of the housing simultaneously.
With a finger nail or with a plastic card you can pull the front flap
forward easily afterwards and have
it come open, connected only by
the hinge at the bottom.
Closing the Keypad
Close the front flap until it clicks into place.
