CombiLock 200 simplex / pro / pro RFID
Handbuch V.1.10
72
INSYS locks
7.2.7
Releasing the Keypad
In order to release the keypad (to change keypads,
for example), open it first (see section
on page 65).
Release the keypad by gently pressing the
protruding plastic piece that prevents the housing
from turning freely round the basic ring with a
small screwdriver to the top while turning the
housing anti-clockwise.
The keypad is released.
7.2.8
Drilling Holes for the Lock
Caution
Improper assembly may cause damage to the lock.
Make sure that the lock is mounted onto an even surface.
Mount the lock in such a way that its bolt is not under pressure
or tension.
Work carried out at and near the lock may cause
irreparable damage.
Do
not insert the boring head into the pre-cast holes
of the
lock.
Do not carry out boring, grinding and welding
at or
near the lock before, during or after the assembly. At and near
the lock, avoid activity that could cause metal cuttings or flying
sparks.
Drill 3 threaded holes M6 according to the drawing below in order to prepare the
attachment of the electronic lock.
A)
Bore for the attachment of the lock
B)
Bore for the attachment of the lock
C)
Bore for the attachment of the lock
D)
Centre shaft of electronic lock
