CombiLock 200 simplex / pro / pro RFID
Handbuch V.1.10
66
INSYS locks
7
Assembly Instructions
for CombiLock 200 simplex, - pro und CombiLock 200 RFID
Assemble and install the electronic lock and the keypad according to these
assembly instructions.
Use the screws delivered with the system or screws exactly meeting the
specifications on the following pages. If requested, use screw retention fluid of
medium strength.
The assembly instructions are part of the VdS approval. Failure to follow these
instructions will invalidate that approval.
Caution
Uneven surfaces may cause functional loss.
Make sure that the lock is mounted to an even surface.
Danger of damage and functional loss of the system
caused by possible contact to aggressive materials.
Do not expose the system components to material with that
they might react chemically (aggressive cleaning agents,
surfaces not yet fully dried and hardened, solvents and
vapours, for example).
Applying too much force can cause damage.
Consequences which might arise from not being aware of
the danger.
Do not use more torque than 1 Nm when fastening the
attachment ring and do not use more torque than 10 Nm when
fastening the lock.
Make sure the electronic lock is protected against tampering from the
outside.
7.1
Assembly - Overview
There are 2 variants of the spindle, A and B.
Spindle A (below on the left) consists of two half pipe pieces and cuffs.
Spindle variant B (below on the right) is a pipe.
System with spindle variant A
System with spindle variant B
The attachment ring is to be mounted at the door with 4 cylinder screws M4x10.
Fasten the lock using 3 x cylinder screws.
