AT Command Set
INSYS Modem 56k small INT 2.0/USB 1.0
46
June 06
Command
Description
AT\B<n>
Send “break” to the other modem
For connections that were not error corrected the modem sends a break signal to the
other modem. The length of the signal is: the specified parameter times 1/10 of a sec-
ond.
For error corrected connections, the modem sends a break signal according to the ac-
tive error correction protocol without considering a parameter specification.
If no connection is established or if a fax connection is active, an error message is dis-
played.
AT\B1
1/10 second break signal
AT\B2
2/10 second break signal
AT\B3
3/10 second break signal
AT\B4
4/10 second break signal
AT\B5
5/10 second break signal
AT\B6
6/10 second break signal
AT\B7
7/10 second break signal
AT\B8
8/10 second break signal
AT\B9
9/10 second break signal
AT%B<n>
Switch key abort on and off during connection
AT%B0
Key abort is active. Each character on the Tx line will result in an
interruption of the connection setup. (default)
AT%B1
Key abort is deactivated. The connection setup cannot be interrupted
manually.
A connection setup can only be interrupted via DTR drop, internal canceling of the
modem (
NO DIALTONE, BUSY
) or Timeout (
NO CARRIER
). (S-Registry 36 Bit 6)
AT%C<n>
Enable
data
compression
Enable/disable a data compression type
The modem can only perform data compression for error corrected connections.
AT%C0
No data compression enabled
AT%C1
MNP 5 data compression enabled
AT%C2
Enable V.42bis and V.44 data compression
AT%C3
Enable MNP 5 and V.42bis data compression (default)