Beeper Behavior
Command
Method
Beeper Disabled
(Default)
Beeper Enabled
On Tap
-
Beep
Off Tap
-
Beep
Fast-On Double-Tap
-
Beep
Fast-Off Double-Tap
-
Beep
Begin Bright
Press & hold
-
Beep
Begin Dim
Press & hold
-
Beep
Setup Action
Beeper
Enter Setup Mode, Transition to next setup mode or Exit
Setup Mode
Beep
Setup successful, return to Ready Mode
Beep-Beep
Return to Ready Mode after a longer than 3 minute time-
out
3 Second ((((((((Beep))))))))))
Failure to add a scene responder
3 Second ((((((((Beep))))))))))
Exiting Stuck Button
3 Second ((((((((Beep))))))))))
LED Behavior During Setup
RemoteLinc 2 has a two-color LED (Green & Red) which displays helpful information.
LED State
Meaning
Add Responder Setup Mode, or
Blinking Green slowly
LED on/off Setup Mode
Blinking Red slowly
Remove Responder Setup Mode
Multi-Add Responder Setup Mode, or
Double-Blinking Green slowly
Beeper on/off Setup Mode
Multi-Remove Responder Setup Mode, or
Double-Blinking Red slowly
Keypad Configuration Setup Mode
Factory Reset
The factory reset procedure clears all settings from RemoteLinc 2 including INSTEON scenes.
1) If possible, unlink (remove) all scene responders prior to performing factory reset
2) Turn RemoteLinc 2 off (slide power switch to left)
3) Press & Hold Set Button
4) While continuing to hold the Set Button, turn RemoteLinc 2 back on (slide power switch to the right)
RemoteLinc 2 will
(Beep)
& LED stays solid
GREEN
Page 11 of 15 2444A2xx4 Rev: 10/24/2011 10:50 AM