OPTIONAL “TIMED”
DISPENSE:
This function is appropriate when the cup/teapot being filled is always the same size/capacity.
To change boiler from
“on
-
demand” default setting to “Timed”
dispense:
1)
Place vessel on spill-tray, within cup aperture (breaking safety light-beam).
2)
Switch off on front of unit
3)
Isolate from mains power supply and wait 10 seconds.
4)
Switch boiler back on and at the same time, hold hand in front of
‘touch
-
free’
sensor.
The
‘
touch-free
’
sensor will begin to flash rapidly, or the boiler will start to fill with water
(depending on water level in tank).
5)
Set the required level within the cup/vessel by holding hand in front of sensor to dispense
water. Release button to stop dispense (NOTE: This can be repeated as many times as
necessary, to get the level correct).
6)
Once level in vessel is correct, press the ON/OFF button (below display) to save the measured
dispense amount (this saves the setting and puts the boiler into standby mode).
7)
To continue, switch boiler back on by pressing the ON/OFF button again.
8)
The boiler will now dispense the measured amount into the cup/teapot, each time the
‘
touch-
free
’
sensor is activated.
Top-up feature:
•
At the end of the timed dispense cycle,
the “CAUTION” message will continue to flash
for a
further 5 seconds. During this 5-second window, the water level in the cup or teapot can be
topped-up by simply activating the dispense via the
‘touch
-
free’
sensor, as described above.
NOTE
: Once the “CAUTION” message stops flashing, the top
-up facility ends and the boiler
reverts back to timed dispense mode.
To change back from “Timed” to standard “on
-
demand”
dispense:
•
Follow steps 1 to 4 (as above)
then; …
•
Wave hand in front of sensor very briefly (for less than 1½ seconds)
, to activate the “on
-
demand” function again.
•
Press ON/OFF button (below display) to save the new setting (boiler will go into standby
mode).
•
To continue, switch boiler back on again by pressing the ON/OFF button. The boiler will now
dispense for as long as the sensor is activated.
REGULAR DAILY USE
Switch boiler on and wait for the screen to turn white and show “READY” message
and touch-free
sensor to illuminate. The water will then be at the correct temperature. (the unit will not dispense
until the water has reached temperature and button is illuminated)
Dispense water by holding hand in front of the touch-free sensor.
